Solenoid Valve Coil - Toro Reelmaster 2000-D Service Manual

Solenoid Valve Coil

The hydraulic system on the Reelmaster 2000–D uses
a solenoid valve coil on the reel drive manifold and,
when equipped with the optional 3WD kit, a second sole-
noid coil on the 3WD manifold.
NOTE: Prior to taking small resistance readings with a
digital multimeter, short the test leads together. The me-
ter will display a small resistance value (usually 0.5
ohms or less). This resistance is due to the internal re-
sistance of the meter and test leads. Subtract this value
from from the measured value of the component you are
testing.
NOTE: The solenoid does not have to be removed from
the valve for testing.
1. Make sure engine is off. Unplug solenoid valve elec-
trical connector.
2. Apply 12VDC source directly to the solenoid. Listen
for solenoid to switch on.
3. Remove 12VDC source from the solenoid. Listen for
solenoid to switch off.
4. Measure resistance between the two coil connector
terminals.
A. Resistance of the reel drive solenoid should be
about 7.2 ohms.
B. Resistance of the 3 wheel drive solenoid (if
equipped) should be about 7.5 ohms.
5. Reconnect electrical connector to the solenoid.
Reelmaster 2000–D
2
1. Reel drive hydraulic manifold
2. Solenoid valve coil
1. 3WD hydraulic manifold
Page 5 – 17
1
Figure 17
1
2
Figure 18
2. Solenoid valve coil
Electrical System