Adjustments; Adjustments; Characteristics - Toro Reelmaster 2000-D Service Manual

Adjustments

Never install or work on the cutting units or lift
arms with the engine running. Always stop en-
gine and remove key first.
See Cutting Unit Operator's Manual for adjustment pro -
cedures for the cutting units on the Reelmaster 2000–D.

Characteristics

The single knob bedknife–to–reel adjustment system in-
corporated in this cutting unit simplifies the adjustment
procedure needed to deliver optimum mowing perfor-
mance. The precise adjustment possible with the single
knob/bedbar design gives the necessary control to pro-
vide a continual self–sharpening action. This feature
maintains sharp cutting edges, assures good quality of
cut, and greatly reduces the need for routine backlap-
ping.
In addition, the rear roller positioning system permits op-
timum bedknife attitude and location for varying height–
of–cuts and turf conditions.
Cutting Units
CAUTION
If a cutting unit is determined to be out of adjustment,
complete the following procedures in the specified order
to adjust the cutting unit properly.
1. Adjust the bedknife parallel to the reel.
2. Set height–of–cut and level the rear roller.
3. Verify height–of–cut and level the front roller.
4. Verify reel to bedknife clearance.
Refer to the Cutting Unit Operator's Manual for adjust-
ment procedures.
Page 7 – 8 Reelmaster 2000–D