Standard Seat - Toro Reelmaster 2000-D Service Manual

Standard Seat

1
12
11
10
1. Seat (incl. 2 thru 7)
2. Seat switch
3. Cap screw
4. Edging clip
5. Edging
Removal
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Remove four cap screws and lock nuts securing the
seat to the machine frame.
3. Disconnect electrical connector from the seat switch.
Separate seat from the frame.
4. Remove seat parts as necessary to make repairs us-
ing Figure 5 as a guide.
Chassis
2
3
9
8
6. Seat cushion
7. Seat shell
8. Seat adjuster
9. Seat adjuster with latch
10. Flange hex nut
Page 6 – 10
4
5
6
7
13
Figure 5
Installation
1. Install any new seat parts using Figure 5 as a guide.
2. Position seat to the machine frame.
3. Connect electrical connector to the seat switch.
4. Secure seat to the frame with four cap screws and
lock nuts.
14
15
11. Cap screw
12. Lock washer
13. Seat stop
14. Cap screw
15. Flange nut
Reelmaster 2000–D