Solenoid Valve Coil - Toro Reelmaster 2000-D Service Manual

Solenoid Valve Coil

The solenoid valve coil on the reel drive (Fig. 30) and
3WD hydraulic manifold, if equipped, (Fig. 31) can be
easily replaced without opening the hydraulic system.
Removal
1. Disconnect the electrical connector.
2. Remove the nut from the spool assembly.
3. Slide the coil assembly and o–rings from the spool
assembly. Discard the coil assembly and o–rings.
4. Clean any corrosion or dirt from the spool assembly.
Installation
1. Slide new coil assembly onto the spool assembly
making sure that o–ring is installed at each end of coil.
Align the coil assembly evenly with the manifold body.
2. Apply medium strength thread–locking compound to
the threads of the spool. Install the nut onto the spool as-
sembly and torque as follows (do not over tighten):
A. Torque nut for reel drive solenoid from 2 to 5 ft–lb
(2.7 to 6.8 N–m).
B. Torque nut for 3WD solenoid from 4 to 6 ft–lb (5 to
8 N–m).
3. Connect the solenoid to the machine wiring harness.
Reelmaster 2000–D
3
2
Thread–locking
compound
4
5
1. Nut
2. Coil assembly
3. O–ring
4 to 6 ft–lb
(5.4 to 8.1 N–m)
Thread–locking
compound
5
1. Nut
2. Coil assembly
3. O–ring
Page 5 – 29
1
2 to 5 ft–lb
(2.7 to 6.8 N–m)
3
Figure 30
4. Spool assembly
5. Reel drive manifold
3
1
2
3
4
Figure 31
4. Spool assembly
5. 3WD manifold
Electrical System