1
Installing the Steering
Wheel
Parts needed for this procedure:
1
Steering wheel
1
Foam collar
1
Washer
1
Locknut
1
Steering-wheel cover
Procedure
1.
Move the front wheel so that it points straight
ahead.
2.
Slide the foam collar, small end first, onto the
steering shaft
(Figure
1. Foam collar
2. Steering wheel
3. Washer
3.
Slide the steering wheel onto the steering shaft
(Figure
3).
4.
Secure the steering wheel to the steering shaft
with a washer and a locknut
5.
Torque the locknut to 27 to 35 N∙m (20 to 26
ft-lb).
6.
Press the steering-wheel cover into position on
the steering wheel
3).
Figure 3
4. Nut
5. Steering-wheel cover
(Figure
3).
(Figure
3).
2
Installing the Seat
Parts needed for this procedure:
1
Seat
Procedure
1.
Remove and discard the lag bolts securing the
seat to the crate.
2.
Remove the nuts from the shipping bracket and
discard the bracket. Save the nuts.
3.
Secure the seat to the seat base with the 4
previously removed nuts; refer to
g025723
1. Seat
2. Seat switch
3. Seat bolts
4.
Locate the machine wire harness and connect
it to the seat switch
5.
Secure the wire harness to the seat base with
a cable tie.
8
Figure
Figure 4
4. Flange nut
5. Machine wire harness
(Figure
4).
4.
g334906