Toro Reelmaster 2000-D Service Manual page 54

Problem
Cutting units will not lift or lift slowly
Cutting units raise, but will not stay
up
Hydraulic System
Possible Cause
Engine speed is too low.
Pump pulley drive belt is loose.
Charge pump is damaged.
Lift valve control linkage is binding or broken.
Lift cylinder bushings are binding.
Reservoir oil level is low.
Inlet filter is loose or clogged.
Charge pump pressure or flow is insufficient.
Implement relief valve is stuck open.
Lift control valve is damaged.
Lift cylinders leak internally.
Lift cylinders leak internally.
Lift valve leaks.
Page 4 - - 18 Reelmaster 2000--D