Specifications; Specifications - Toro Reelmaster 2000-D Service Manual

Specifications

MOUNTING: All cutting units are supported by equal
length, independent lift arms and are interchangeable to
all three cutting unit positions.
CONSTRUCTION: 5, 8, or 11 blades of 7 inches (18 cm)
diameter welded to stamped steel spiders. Reels are
mounted on greaseable self–aligning ball bearings. Cut-
ting unit reel length of either 27 inches (69 cm) or 32
inches (81 cm).
HEIGHT OF CUT RANGE:
Floating Cutting Unit – 1/4 to 1–3/4 inches
(6mm to 44mm).
Fixed Cutting Unit – 1/2 to 2–5/8 inches
(13mm to 67mm).
POWER: Hydraulic reel motors allow easy removal
from or installation onto the cutting unit. Cutting units
can be driven from either end.
HEIGHT–OF–CUT &
Height–of–cut adjustment is made with the rollers by a
quick locating pin and/or threaded micro–adjustment.
BEDKNIFE AND BEDBAR ADJUSTMENT: A single
knob screw adjustment for bedknife to reel is located at
the center of the bedbar.
CUTTING UNIT LIFT: Hydraulic lift has an automatic
reel shut off. Lift for all cutting units are controlled from
one lever.
Cutting Units
ROLLER ADJUSTMENT:
Figure 1
SUSPENSION SYSTEM: A fully floating suspension
with hydraulic counterbalance. L–I–N–K–S
unit suspension system provides fore and aft oscillation.
Main center pivot allows side–to–side oscillation. With
optional Fixed Kit (Part No. 93–6915), cutting units can
be locked into fixed (fore/aft) position for use with skids
or anti–scalp rollers.
CLIP FREQUENCY: With variable speed set to maxi-
mum reel RPM (1040 RPM):
Reel Blades
5 (27" or 32")
5 (27' or 32")
8 (27' or 32")
8 (27' or 32")
11 (27" only)
11 (27" only)
CUTTING UNIT WEIGHT:
Model 03210 (27" 5 blade)
Model 03211 (27" 8 blade)
Model 03214 (27" 11 blade)
Model 03212 (32" 5 blade)
Model 03213 (32" 8 blade)
Page 7 – 2
Ground Speed Clip Frequency
1.00" (25mm)
5 mph (8 km/h)
1.20" (30.5mm)
6 mph (9.7 km/h)
0.63" (16mm)
5 mph (8 km/h)
0.76" (19mm)
6 mph (9.7 km/h)
0.46" (12mm)
5 mph (8 km/h)
0.55" (14mm)
6 mph (9.7 km/h)
136 lb (62 kg)
143 lb (65 kg)
149 lb (68 kg)
158 lb (72 kg)
167 lb (76 kg)
Reelmaster 2000–D
TM
cutting