Toro Reelmaster 2000-D Service Manual page 32

5
28
29
7
6
3
4
2
20
10
3
RIGHT
FRONT
1. Engine
2. Flywheel stub shaft
3. Cap screw
4. Flat washer
5. Bushing
6. Pulley
7. Key
8. Hardened washer
9. Lower alternator bracket
10. Front engine frame
16.Remove engine from machine (Fig. 15).
A. Attach short section of chain between lift tabs lo-
cated on each end of the cylinder head.
B. Connect a hoist or chain fall at the center of the
short section of chain. Apply enough tension on the
short chain so that the engine will be supported as
the engine mount brackets are removed.
C. Remove cap screws, snubbing washers, and
lock nuts that secure the engine (with frames and
channel) to the engine mounts.
Engine
Lift Tab
Lift Tab
1
4
22
11. Rear engine frame
12. Engine channel
13. Flange head screw
14. Flange nut
15. Cap screw
16. Flat washer
17. Lock nut
18. Upper alternator bracket
19. Alternator
20. Cap screw
20
25
17
4
24
23
27
21
Figure 15
One person should operate lift or hoist while the
other person guides the engine out of the ma-
chine.
IMPORTANT: Make sure not to damage the engine,
fuel hoses, hydraulic lines, electrical harness, or
other parts while removing the engine.
D. Remove engine (with engine frames and chan-
nel) from the machine.
Page 3 – 16
19
9
8
13
15
11
18
20
12
14
22
23
22
27
21. Lock nut
22. Snubbing washer
23. Engine mount
24. Cap screw
25. Cap screw
26. Cap screw
27. Lock nut
28. Cap screw
29. Lock washer
CAUTION
Reelmaster 2000–D
16
26