Status Indicators; Using The Touch Screen - Eaton Power Xpert Plus 1 Installation And Operation Manual

7.6.1

Status Indicators

The symbols on the bottom of the control panel are status indicators. These colored
light emitting diode (LED) lamps work with the alarm horn to let you know the
operating status of the UPS. See Table 7‐6.
Table 7‐6. Status Indicators
Indicator
Green
Yellow
Yellow
Red
7.6.2

Using the Touch Screen

The touch screen control panel provides an operator interface with the UPS system.
Figure 7‐10 identifies the display areas discussed in the following sections.
Touching anywhere on the screen brings up the Sign In Request pop-up. Touch the X
in the upper right corner of the pop-up, then touch the padlock symbol in the upper
right corner to obtain the password request pop-up (see Figure 7‐11).
A
B
t
Power Xpert 9395 UPS (450–550 kVA) Installation and Operation Manual
Status Description
Lit Steady The UPS is in Online mode, operating normally. The power module is supplying power
to the critical load.
Lit Steady The UPS is in Battery mode. Because Battery mode is a normal condition of the UPS,
the Online indicator also remains illuminated.
Lit Steady The UPS is in Bypass mode. The critical load is supported by the bypass source. The
Online indicator is not illuminated when the system is in Bypass mode.
Lit Steady The UPS has an active alarm and requires immediate attention. The screen shows the
highest priority active alarms. All alarms are accompanied by an audible horn. To
silence the horn, press any control panel pushbutton once. The Alarm indicator may
be illuminated along with other indicators.
Lit Flashing There is a new UPS alarm condition. The indicator flashes until acknowledged by
pressing anywhere on the control panel once.
Figure 7‐10. Parts of the Touch Screen
UPS OPERATING INSTRUCTIONS
S
www.eaton.com/powerquality
164201701 Rev 4
7-47