Lcd Customer Display - Micros Systems Workstation 4 LX Service Manual

Remove and Replace the WS4 and WS4 LX FRUs

LCD Customer Display

LCD Customer Display

This section describes how to disassemble the Rear or Pole LCD Customer Display in
order to access the LCD module, interface board, interface cable, and mounting hinge.
The replacement part number of each component can be found in Chapter 1.
1. Place the display face down on the work surface and remove the two captive
screws from the rear cover. Figure 6-35.
Figure 6-35: Removing the LCD Customer Display cover
2. To remove the LCD Module, remove the two screws shown in Figure 6-36.
3. Place the LCD module face down in front of the unit to expose the internal cables.
6-30
Figure 6-36: Removing the LCD Module
Workstation 4 and 4 LX Field Service Guide