Micros Systems Workstation 4 LX Service Manual page 211

7. Before closing the cover, if the mag card reader cable includes a toroid, place it in
the cable clamps mounted to the shield. Figure 6-33.
Figure 6-33: Securing the Mag Card Reader Cable to the RF Shield (Older Units Only)
8. If the workstation includes an optional Rear LCD Customer Display, connect it to
the customer display cable projecting from the display housing.
9. Orient the LCD assembly as shown in Figure 6-34 and place the hinge assembly
in the top cover cut-out, before fitting the top cover to the base.
Figure 6-34: Installing the Rear Customer Display
10. Tighten the cover screws to secure the top cover to the base.
Workstation 4 and 4 LX Field Service Guide
Remove and Replace the WS4 and WS4 LX FRUs
Reassembling the RF Shield
6-29