Connector and Cable Diagrams
LCD Customer Display Cables
LCD Customer Display Cables
The Rear and Pole LCD Customer Displays use three cable assemblies. The function
of each cable and part number are detailed in the following pages. Each cable can be
used with the Workstation 4 or Workstation 4 LX System Boards as required.
System Board Integrated Cable
This cable is attached to WS4 or WS4 LX System Board connector J1. A diagram is
shown in Figure A-11. This cable mates with the cable from the LCD customer
display assembly, shown in Figure A-12.
Figure A-11: System Board to Rear LCD Customer Display
LCD Customer Display Assembly Interface Cable
A diagram of this interface cable is shown in Figure A-12. This cable is used for both
the Rear and Pole versions of the Customer Display.
When the LCD customer display is attached directly to the rear of the workstation, this
cable plugs into the system board cable shown in Figure A-11.
When the LCD customer display assembly is mounted on the pole, or to the adjustable
stand mounted pole display, this cable attaches to the pole extension cable shown in
Figure A-13.
A-8
Workstation 4 and 4 LX Field Service Guide