Adjusting The Pressure Of Curl Eliminator Mechanism - Kyocera Mita KM-3530 Service Manual

3B5

(4) Adjusting the pressure of curl eliminator mechanism

Increase the pressure of the curl eliminator mechanism to reduce upward curling of paper stacked on the intermediate tray
if a paper jam occurs when batch ejection is performed because of strong upward curling.
Procedure
1. Remove the paper conveying unit from the
copier.
2. Loosen the two screws from the front and
rear curl eliminator pressure adjusting plates
respectively and then remove the plates.
3. Refit the all removed parts.
Curl eliminator pressure
adjusting plate
1-4-4
Paper conveying unit
Figure 1-4-4
Curl eliminator pressure
adjusting plate