Table of Contents
Advertisement
(3-4) Adjusting the margins for printing
Make the following adjustment if the margins are not correct.
U403
U402
(P. 1-6-31)
Caution:
Check the copy image after the adjustment. If the margins are still incorrect, perform the above adjustments in
maintenance mode.
Procedure
Start
Enter maintenance mode.
Enter "402" using the numeric keys.
Press the start key.
Select the items to be adjusted.
Press the interrupt key.
Press the start key to output a test
pattern using A3/11" × 17" paper.
Are the margins correct?
Yes
Proceed to
another mode?
Press the stop/clear key to
exit maintenance mode.
End
U404
(P. 1-4-49)
LEAD
AC
TRAIL
TRAIL (DUP) : printer trailing edge margin for
Change the setting.
Increasing the value using the cursor up
No
key makes the margin winder.
Decreasing the value using the cursor
down key makes the margin narrower.
Yes
Setting range (initial setting)
Printer leading edge margin: 0 – +10 (3.7)
Printer left/right margin: –5 – +10 (2.7)
Printer trailing edge margin: –5 – +10 (3.5)
Printer trailing edge margin for duplex copying
(second face): –5 – +10 (3.5)
No
Changing the value by 1 moves the center line by 0.5 mm.
Printer leading edge margin
(6 ± 2.5 mm)
Printer
left margin
(6 ± 2.0 mm)
Printer trailing edge margin
(6 ± 2.5 mm)
Normal copy mode
(A3/11" × 17")
: printer leading edge margin
: printer left/right margins
: printer trailing edge margin
duplex copying (second face)
Press the start key.
The new setting is stored.
Ejection direction
(reference)
Printer
right margin
(6 ± 2.0 mm)
Figure 1-6-24
2BH/J-3
Printer trailing edge margin
(6 ± 2.5 mm)
for duplex copying
Duplex copy mode
(second face, A3/11" × 17")
1-6-13
Advertisement
Chapters
Table of Contents
