Kyocera Mita KM-3530 Service Manual page 46

2BH/J
7. Remove the two screws securing the shield
cover and then the cover.
8. Detach the 10-pin connector (four wires) from
CN4 on the main PCB and connect it to J2 on
the IPC PCB.
10-pin connector
J2
9. Connect J1 on the IPC PCB to CN15 on the
main PCB.
10. Insert the three board supports of the IPC
PCB into the main PCB to secure them.
11. Refit the shield cover.
1-3-26
IPC PCB
IPC PCB
Main PCB
Screws
Figure 1-3-40
Main PCB
CN4
10-pin connector
Figure 1-3-41
CN15
Board support
Figure 1-3-42
Shield cover
CN15
Board
supports
J1
IPC PCB