8. Detach the open connector from the connector
of the main harness on the machine rear.
9. Insert the dehumidifier heater connectors into
the relay wire connectors.
10. Insert the main harness connector into the
relay wire connector.
11. Tidy up the dehumidifier heater cable and relay
wire using the eight wire saddles and route the
cable and wire while clipping the wire saddles
into the holes in the rear frame.
12. Refit all removed parts.
Wire saddle
Wire
saddles
Wire saddles
Open connector
Main harness
Figure 1-2-4
Relay wire
Figure 1-2-5
5FF
Wire saddles
1-2-3