Kyocera Mita KM-3530 Service Manual page 43

10. Turn the four leveling bolts until they reach
the floor and adjust them to level the
machine.
11. Fit the stay to the lower left of the large paper
deck toward the rear using the two M4 × 16
chrome TP screws such that it makes contact
with the floor.
Note: Do not fit the stay if the finisher is to be
installed.
Setting the paper size
1. Open the large paper deck.
2. Move the sliders at the machine front and
rear inward (two at each point).
3. Remove the screw from each of the front and
rear lateral size adjusters.
Figure 1-3-32
Stay
Figure 1-3-33
Lateral size adjuster
Sliders
Lateral size adjuster
Figure 1-3-34
Leveling bolts
M4 × 16 chrome
TP screws
Screw
Screw
2BH/J-1
Sliders
1-3-23