Installing The Optional Add-On Memory - Kyocera Mita KM-3530 Service Manual

1-2-2 Installing the optional add-on memory

Add-on memory installation on the fax control PCB assembly requires the following parts:
8 MB add-on memory (P/N: 2AW6001)
<Procedure>
1. Remove 13 screws and take off the rear cover.
2. If the printing system is installed: Remove the 2 screws holding the
printer system in place, and pull the printing system out of the
controller box.
3. Remove 13 screws and take off the controller-box cover.
Rear cover
Figure 1-2-1
Printing system
Screws
Figure 1-2-2
Controller-box
cover
Figure 1-2-3
3CM
Screws
Screws
1-2-3