Kyocera Mita KM-3530 Service Manual page 76

2BH/J
6. Insert the job separator into the copier from
the front side and slide it to the left. Secure
the front side using a +TP-A bronze screw M3
× 05 and the rear side using a pin.
* Check to see if the branch pressure lever on
the rear side of the job separator has
lowered.
+TP-A bronze screw
M3 × 05
7. Connect the connector of the job separator to
the lower connector of the copier.
8. Attach the job separator tray to the rail of the
job separator by sliding it from the front side.
* Insert the fitting section on the right side of
the job separator tray into the recessed
portion of the copier.
* Put the hook on the right side onto the pin.
9. Reattach the left front cover in its original
position.
Job separator
tray
10. Insert the power plug of the copier into an
outlet and turn the main switch on.
11. Set the "copy ejection location" of the
machine default settings to job separator.
12. Make a test copy to check that a copy is
ejected to the job separator tray.
1-3-56
Job separator
Rail
Figure 1-3-124
Connector
Connector of the copier
Figure 1-3-125
Fitting section
Hook
Pin
Figure 1-3-126
Pin
Recessed portion