Kyocera Mita KM-3530 Service Manual page 60

2BH/J
• If the printing system was installed
27. Reinstall the printing system into the shield
cover, fastening it into place with 2 screws.
28. Reattach the rear cover with 13 screws.
29. Adhere the certification labels to the rear
cover at the locations indicated in the
illustration (only 120 V Spac.).
1-3-40
Printing system
Screws
Figure 1-3-79
Figure 1-3-80
Certification
labels
Figure 1-3-81
Rear cover
Screws