Kyocera Mita KM-3530 Service Manual page 49

20. Fit the eject tray to the finisher by hooking the
two claws and secure it using two M4 × 6
binding screws.
21. Open the front panel and insert the stapler
unit into the finisher.
22. Close the front panel.
Installing the switchback unit
1. Remove the two support rubbers on the right
of the finisher and loosely fit the two M3 × 8
binding screws in their places.
2. Remove the two screws.
Claw
Eject tray
M4 × 6
binding screws
Figure 1-3-49
Front panel
Figure 1-3-50
Support rubber
Screw
Figure 1-3-51
2BH/J
Claw
Stapler unit
Finisher
Screw
Support rubber
M3 × 8
binding screws
1-3-29