Kyocera Mita KM-3530 Service Manual page 228

2BH/J
(7) Adjusting the longitudinal squareness (reference)
Perform the following adjustment if the copy image is longitudinally skewed (longitudinal squareness not obtained).
Caution:
• Adjust the amount of slack in the paper (page 1-6-14) first. Check for the longitudinal squareness of the copy image,
and if it is not obtained, perform the longitudinal squareness adjustment.
• Before making the following adjustment, output a VTC-PG2 pattern in maintenance item U993 to use as the original for
the adjustment.
Procedure
Start
Place the original
on the contact glass.
Press the start key and make
a test copy at 100% magnification.
Is the image correct?
End
1-6-26
No
Yes
Original
Figure 1-6-52
Retighten the two screws and
refit the contact glass.
Remove the contact glass.
Loosen the two screws and
adjust the position of the
mirror 2 frame.
For copy example 1,
move the frame in the direction of
the white arrow (e).
For copy example 2,
move the frame in the direction of
the black arrow (b).
Mirror 2 frame
Figure 1-6-53
Copy Copy
example 1 example 2
Screws