Kyocera Mita KM-3530 Service Manual page 71

6. Remove the two screws and then remove the
inner ejection cover.
7. Insert the transfer unit into the copier from the
front side and slide it to the left.
Secure the unit using two +TP-A bronze
screws M3 × 05 and the pin that has been
fitted to the transfer unit.
Transfer unit
8. Insert the metal hook of the transfer unit into
the oblong hole of the frame of the copier and
secure it using a +TP-A bronze screw M3 ×
05.
* Insert the projection of the frame into the
hole of the metal hook to position the hook.
* Arrange the cable to position it under the
metal fittings.
Screws
Figure 1-3-110
+TP-A bronze screw M3 × 05
+TP-A bronze screw M3 × 05
Figure 1-3-111
Metal fittings
+TP-A bronze
screw M3 × 05
Cable
Figure 1-3-112
2BH/J
Inner ejection
cover
Pin
Hook
Oblong hole
Hole
Projection
1-3-51