Kyocera Mita KM-3530 Service Manual page 93

Hide thumbs Also See for KM-3530:

Table of Contents

Adjusting the DF center line

Adjusts the scanning start position for the DF original.

To be executed if there is a regular error between the centers of the original and the copy image when the

optional DF is used.

Before making this adjustment, ensure that the following adjustments have been made in maintenance mode.

Press the start key. The screen for executing is displayed.

1. Change the setting using the cursor up/down keys.

DF center line

Increasing the setting moves the image to the right, and decreasing it moves the image to the left.

2. Press the start key. The value is set.

Interrupt copy mode

While this maintenance item is being performed, copying from an original can be made in interrupt copy mode.

1. In interrupt copy mode, make a copy using the DF.

2. Check the copy image and adjust the center line as follows.

For copy example 1, increase the setting.

For copy example 2, decrease the setting.

Press the stop/clear key at the screen for selecting an item. The screen for selecting a maintenance item No. is

Setting range

Initial setting

Figure 1-4-3

Change in value per step

Chapters

Table of Contents