5062
3.
Remove the screw (C), and then disconnect the cable (B) from the card to remove the beacon.
Note: Observe the cable routing for reinstallation. To replace the cable, remove the rear cover and
disconnect the cable from the printer circuit board. See
page
4-239.
5-bin mailbox controller card removal
1.
Remove the mailbox from the printer.
2.
Remove the rear cover. See
3.
Disconnect all cables from the board.
4.
Remove the two screws (A) to remove the board.
4-230
Service Manual
"5-bin mailbox rear cover removal" on page
"5-bin mailbox rear cover removal" on
4-239.