5062
5.
Disconnect the cable (B) from the sensor, and remove three screws (C).
6.
Disconnect the cable from the system board (JCVR1).
7.
Route the cable through the printer to remove the assembly. Clip and remove cable ties as needed.
Note: Observe the cable routing for reinstallation.
ITU assembly removal
See
"Left (continued)" on page 7-13
1.
Remove the waste toner container. See
2.
Remove the print cartridges.
3.
Open the left access door assembly all the way.
4-72
Service Manual
C (88A0323)
B
for the part number.
"Waste toner container removal" on page
A (88A0323)
4-147.