Skew - Lexmark C792e 5062-210 Service Manual

5062

Skew

Leading edge
Trailing edge
Step
1 Check printer installation placement.
Check the installation surface for irregularities.
Check for damaged printer caster.
Is the setup surface normal?
2 Properly load media into the media tray assembly and
ensure all guides are set correctly.
Properly install the media tray assembly into the printer.
Re-print the defective image.
Does the error continue?
3 Check for obstructions in the area of the media feed
units.
Are the media feed unit assemblies free from any
obstructions?
4 Check the ITU assembly for contamination and wear.
Is the above component free of excess wear and
contamination?
5 Check the printhead for proper alignment.
Go to
Does the problem remain?
6 Perform a print test.
Does the problem remain?
2-36
Service Manual
Questions / actions
"Aligning the printhead" on page
Yes
Go to step 2.
Go to step 3.
Go to step 4.
Go to step 5.
Go to step 6.
4-124.
Contact next
highest level of
tech support.
No
Correct the
installation
placement.
Problem solved.
Remove
obstructions.
Replace ITU
assembly.
Go to "ITU
assembly
removal" on
page 4-72.
Problem solved.
Problem solved.