Input, S1, narrow media, and near narrow media sensor service check
Step
Questions / actions
1
Open the left access door. Check the sensor
flag for damage.
A—Input sensor
B—S1 sensor
C—Narrow media sensor
D—Near narrow media sensor
Is the sensor flag damaged?
2
Turn the printer off, and open the system
board shield. Check the cable in connector
JPP2 for proper connection to the system
board.
Is the cable properly connected?
3
Check the cable in connector JPP2 for
damage.
Is the cable damaged?
Yes
Replace the input sensor.
See
"Sensor (input, S1,
narrow media, near
narrow media) removal"
on page
4-133.
Go to step 3.
Replace the paper path
cable. See
"Paper path
cables" on page
7-35.
No
Go to step 2.
Reseat the cable.
Go to step 4.
2-121
Diagnostic information
5062