Lexmark C792e 5062-210 Service Manual page 366

5062
3.
Disconnect all cables from the system board and feed them through the slots in the system board cage.
Note: Some cables have special connectors that require you to press in tabs to disconnect the cables.
4.
Remove the screw (B).
5.
Tilt the cage forward and slide it up to remove it.
Installation notes:
•
Be sure to reinstall any toroids you had to remove.
•
Some connectors have the same number of pins, so be sure each cable is connected to the correct
connector. For diagrams and tables showing where each cable connects, see
4-146
Service Manual
B (88A0212)
"Locations" on page 5-1.