Lexmark C792e 5062-210 Service Manual page 219

a.
Swing the shield open about an inch, and then slide the shield to the left to remove it.
4.
Carefully unplug the printhead video cables (B) and the printhead motor cable (C) from the system board,
and carefully connect the printhead video and motor cables from the new printhead to the system board.
Note: Use the packaging that came with the printhead FRU to prop up the printhead.
C
5.
Connect the power cord to the outlet and to the printer. Reconnect any cords.
6.
Turn on the printer, and check for the error message:
•
If the error still appears, replace the system board. See
•
If the error no longer appears, replace the printhead. See
alignment" on page
B
4-119.
"System board removal" on page
"Printhead removal, installation, and
Diagnostic aids
5062
4-142.
3-41