Lexmark C792e 5062-210 Service Manual page 229

12.
While holding the front piston, pull out the pin (H) to disconnect the piston from the printer.
Note: The piston is under pressure from the spring. Hold the piston firmly as you remove the post.
13.
Lift the door up slightly and out to remove it.
Installation:
1.
Place the MPF cover on the bottom of the left cover, and hold it in place while you put the assembly into
place.
2.
Replace the pins, making sure the flat side of each pin faces away from the printer.
3.
Reconnect the rear piston, and then reconnect the front piston.
4.
Close the left access door, open the MPF, and replace the inner cover of the MFP.
5.
Close the MPF, open the left access door, and reconnect the cables.
6.
Replace the three screws in the cable cover.
7.
Close the left access door.
H
5062
4-9
Repair information