Tcp/Ip Setup - Digital Watchdog DWC-PV2M4T User Manual

Setup -

TCP/IP Setup

Network Type
1
Select the network type from Static Mode for fixed IP or
Dynamic Mode for dynamic IP address.
If Static is selected, manually enter the camera's IP Address,
Subnet Mask, Gateway, DNS Server and all ports.
If Dynamic is selected, the camera's network settings will
be assigned automatically by your DHCP router. If you click
'Apply', the system will re-boot. To access the camera again,
open an Internet Explorer browser and enter the camera's
new IP address in the address bar.
IP Address
2
View or edit the camera's IP address. The address consists
of four numbers separated by dots, each ranging from 0 to
255.
Subnet Mask
3
View or edit the camera's Subnet Mask.
4 Default Gateway
View or edit the Gateway IP Address. This is your router's
public IP address, and will be used if you are trying to
access the camera remotely over the internet.
Preferred DNS Server
5
View or edit the DNS server IP address.
Port
6
The camera requires five ports for different services. To get
those services separately, unique port number must be
assigned to each service.
IPv6 Setting
7
Create an IPv6 address. If you click 'Apply' after checking
the IPv6 box, the system will re-boot. If you re-visit this
screen after the camera completes rebooting, the IPv6
address will be shown.
To use IPv6, network camera has to connect with the router for
IPv6.
Click 'Apply' to save all changes.
8
If the network type is dynamic, the camera's IP address will
in cases as below. The IP address will have to be searched
again, and the camera will have to be reconnected each
time.
- When the camera powers off.
- After Firmware update, Default set and reboot.
It is recommended to set a DDNS address for the camera.
This allows you to connect to your camera using the same
URL all the time, regardless of IP address change.
34
1
2
3
4
5
6
7
8