Switching The Microsd Card - Fujitsu M10-4 Service Manual

Figure 9-55 Screws for both ends of the XSCF cable connection ports (for the
9.5

Switching the microSD Card

After replacement of the CPU memory unit lower, the firmware version may be
different from the one before the replacement. To use the same firmware version as
that used before the replacement, remove the microSD card from the CPU memory
unit lower being replaced, and then install it in the replacement CPU memory unit
lower.
1.
Remove the screw of the microSD card protective tape (A in the figure) that is
fixed on the removed CPU memory unit lower.
Note - Be careful not to drop the removed screw onto the board of the CPU memory unit
lower.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ November 2014
234
SPARC M10-4S with a FRAME-A CPU memory unit)