Fujitsu M10-4 Service Manual page 65

filler unit that has been stored in a safe place onto the empty slot.
Note the following points when performing PCIe card removal:
Release the multipath depending on the use of a PCIe card when performing
■
active/hot maintenance or active/cold maintenance with PHP.
For active removal by PHP, confirm that the card is PHP supported. To do so,
■
check "Appendix A Cards that Support PCI Hot Plug and Dynamic Reconfiguration"
in the Fujitsu M10/SPARC M10 Systems PCI Card Installation Guide.To perform
active removal using PHP combined with dynamic SR-IOV and the dynamic
reconfiguration function of PCIe end point devices, check the applicable cards by
referring to "Appendix B Cards that Support SR-IOV" or "Appendix D Cards
that support the dynamic reassignment function for the PCIe end point device
(PCIe card)" in the same manual.
When performing PCIe card removal, remove the PCIe card from the PCIe card
■
cassette and then attach the filler that has been stored in a safe place.
Chapter 4 Preparation and Precautions for Maintenance 51