Fujitsu M10-4 Service Manual page 37

Table 2-7 Functions of the power switch (continued)
Icon Operation
Long press
(For 4 seconds or
more)
*1 If the system has been started, it means that at least one physical partition has been powered on.
Table 2-8
Table 2-8 Functions of the mode switch
Function
Starting/Stopping the system
by the power switch
Inhibition of break signal
reception
Description
If the system is stopped in
Locked mode:
If the system has been
started in Service mode
(*1):
If the system startup
process is in progress in
Service mode:
If the system stop process
is in progress in Service
mode:
If the system is stopped in
Service mode:
If the system is stopped in
Locked mode:
If the system is not
stopped in Locked mode:
describes the functions of the mode switch.
Mode switch
Locked
Only system startup is enabled.
Enabled. Using the setpparmode
command, it is possible to specify
whether break signal reception is
allowed or inhibited for each physical
partition.
Starts the system.
At this time, if a wait time for the air conditioning
facilities or a warm-up time is set on the XSCF,
the processing for waiting for the power-on of the
air conditioning facilities and the completion of
warm-up is omitted.
Perform the system shutdown process to stop the
system.
Cancels the system startup process and then
stops the system.
Continues the system stop process.
Operation is ignored.
Even a long press does not start the system.
Starts the system.
If a wait time for the air conditioning facilities or
a warm-up time is set on the XSCF, the
processing for waiting for the power-on of the air
conditioning facilities and the completion of
warm-up is omitted.
Operation is ignored.
Chapter 2 Understanding the System Components
Service
A long press
shuts down the
system.
Disabled
23