Removing A Cpu Memory Unit From The Chassis - Fujitsu M10-4 Service Manual

Figure 9-5 Screws securing the mounting frame
9.3.2

Removing a CPU memory unit from the chassis

This section describes the procedure for removing a CPU memory unit.
Note - To install or remove a CPU memory unit upper, it is necessary to remove the CPU
memory unit from the chassis.
1.
Loosen the one screw securing the lever of the CPU memory unit (rear left
side) and then lower the right and left levers of the CPU memory unit to the
horizontal position.
Figure 9-6 Locations of the screw and the levers of the CPU memory unit
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ November 2014
192