2.
Execute the showboards command to confirm the BB-ID of the chassis in
which the disk requiring maintenance is mounted.
Identify the BB-ID from the LSB number confirmed in step 1. The BB-ID of the
chassis requiring maintenance is indicated by the system board (PSB) number.
XSCF> showboards -a
PSB PPAR-ID(LSB) Assignment Pwr Conn Conf Test Fault
---- ------------ ----------- ---- ---- ---- ------- --------
00-0 00(00) Assigned y y y Passed Normal
* BB#0 * LSB#0
01-0 00(01) Assigned y y y Passed Normal
Releasing an internal disk from the system
1.
Execute the cfgadm(1M) command to check the configuration of the internal
disk.
To replace or remove an internal disk, use the cfgadm -al command to check the
Ap_ID of the disk requiring maintenance and make a note of it.
If multiple internal disks are mounted, check for the disk that matches the
physical device name confirmed in
In the following execution example, Ap_ID is "c2::dsk/c2t50000394281B59D6d0".
# cfgadm -al
Ap_Id Type Receptacle Occupant
Condition
< Omitted >
c2 scsi-sas connected configured
unknown
c2::dsk/c2t50000394281B59D6d0 disk connected configured
unknown
c2::es/ses0 ESI connected configured
unknown
c2::smp/expd0 smp connected configured
unknown
c3 scsi-sas connected unconfigured
unknown
c4 scsi-sas connected unconfigured
unknown
c5 fc connected unconfigured
unknown
c6 fc connected unconfigured
unknown
c7 scsi-sas connected unconfigured
unknown
< Omitted >
2.
Stop all applications from using the internal disk.
3.
Execute the cfgadm(1M) command to release the internal disk requiring
maintenance from the system.
Enter the Ap_ID you noted in advance.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ・ November 2014
68
"How to identify a disk
slot."