00 : Powering off
*Note*
This command only issues the instruction to power-off.
The result of the instruction can be checked by the "showpparprogress".
8.
Execute the showpparstatus command to confirm that the power to the
physical partition is turned off.
In the following example, [PPAR Status] displays "Powered Off" for PPAR-ID 00,
indicating that the power to the physical partition has been turned off.
XSCF> showpparstatus -p 0
PPAR-ID PPAR Status
00 Powered Off
5.6
Stopping the Entire System
This section describes the procedure for stopping the entire system. To undertake
system-stopped maintenance, power off all the physical partitions to stop the entire
system before physically removing any FRU.
Stop the system in either of the following two ways.
Stopping the system with the XSCF command
■
Stopping the system from the operation panel
■
Note - Before stopping the system, inform the users that the system will be stopped.
Note - When a physical partition is stopped by the operation of the XSCF command or the
operation panel, all the logical domains on the physical partition are stopped. Stop
applications as required.
5.6.1
Stopping the system with the XSCF command
1.
Confirm that the mode switch on the operation panel is in Service mode.
2.
Log in to the XSCF shell.
3.
Execute the poweroff command.
Enter "y" in response to the confirmation message.
In the following example, the displayed status of PPAR-IDs 00, 01, and 02 is
"Powering off," so you can see that the power-off instruction for the physical
partition completed successfully.
Chapter 5 Preparations Required for Maintenance
73