Standby Status In Hunt Group - Aastra DT690 User Manual

19.3

Standby status in Hunt Group

When you belong to one or several hunt groups, you may also manage your
availability for answering calls that are directed to your group(s).
This standby service enables you to temporarily withdraw from a hunt group.
Therefore, you would only receive personal calls, or those that are directed to
the groups from which you have not withdrawn.
Once again, the system distinguishes your position in relation to your primary
group as well as your secondary groups.
To manage your group standby status, from an idle extension:
1. Dial 6 8 to proceed to standby within your primary group.
2. Press
3. Wait for the Service Acceptance Tone.
4. Press
1424-EN/LZT 103 090 Uen A1 2008-10-24
Note: The simplified call pick-up described above applies only if the call
that is picked up is for the group involved, or a personal call for a
member of the involved group.
If several calls are ringing within the same group, the oldest call
will be automatically selected. If several calls are ringing within
different secondary groups, the call that is picked up will be
automatically selected by the system.
Your extension may also be subject to call pick-up from third party
sets that belong to the same group as you. The call pick-up access
prefix within secondary groups differs from one facility to another.
.
If your extension was active within your primary group, it will now be on
standby. On the other hand, if your extension was on standby, it will now
be active within your primary group.
In relation to your secondary groups, your extension's active or inactive
status is changed for all of them at the same time. In either case the service
acceptance tone is played.
to finish the procedure.
Your extension returns to idle status.
Group Services
105