Hunt Group Opening / Closing; Personal Group Services - Aastra DT690 User Manual

DT690
Note: The prefix for accessing the standby service within secondary groups
19.4

Hunt Group Opening / Closing

You may be designated as a supervisor for one or several hunt groups,
regardless of whether or not you are a member of it (them). This is established
by a right that is assigned specifically to you by your system administrator.
In relation to this (these) hunt group(s) for which you are in charge, it is your
responsibility to open and close traffic for each one, according to its members'
business hours.
To open or close traffic to a hunt group, from an idle extension:
1. Dial the prefix to open/close hunt groups.
2. Dial the internal number for the involved hunt group.
3. Press
4. Press
If the hunt group was previously open to traffic, it then progresses to a closed
status, and will no longer accept calls.
Calls to this group will then be directed to an overflow extension or group,
or a dissuasion message that may be pre-defined in terms of each group's
configuration.
On the other hand, if the hunt group was previously closed to traffic, it then
progresses to an open status, and will now accept calls.
Note: Only a supervisor may manage this open or closed group status.
19.5

Personal Group Services

While it is not really a group service, you also have access to a personal group,
which is designed for grouping various extensions that may be assigned to you
(up to 5 extensions).
The specific services offered to you are as follows:
106
differs from one facility to another.
You may place your extension on standby at any time, even if you are
the last active member of a group. Your status is managed completely
independently from the opening and closing of traffic for a specific
group, which is the sole responsibility of the hunt group supervisor.
This varies from one facility to another.
and wait for the Service Acceptance Tone.
to end this service.
1424-EN/LZT 103 090 Uen A1 2008-10-24