Table of Contents
Advertisement
Installing the on-board disk drives
The CPV5000 has an optional, on-board EIDE drive and a floppy drive.
Installation instructions
Use the following procedure to install the on-board disk and floppy drives.
A number one Phillips screwdriver is needed for this procedure.
1. Remove power from the chassis and disconnect all power cords.
Remove the CPV5000 from the chassis.
2. Locate the drive headers on the CPV5000.
J9
J6
Removing and Replacing the Battery
FLOPPY
J8
J7
J12
IDE
2167 9803
5-7
5
Advertisement
Table of Contents
