Connectors and Components on the CPV5000
USB configuration
The USB configuration jumper is a two by four jumper block. A four position
shorting block is installed to select the USB routing. To maintain signal
3
integrity, the USB signals can be routed to the rear connector. If rear connector
routing is selected, no USB devices can be installed on the front connector.
Table 3-4 indicates which side the shorting block should be installed to select
the front or rear connector.
Front panel connectors
Table 3-5 specifies the connectors that are available from the front panel.
Location
J23
J22
J16
J19
J17
J18
J21
3-6
Table 3-4. USB configuration jumpers
Jumper J27
Installed
Rear connector
Removed
Front connector
Table 3-5. Front panel connectors
Type
25-pin micro-D
2x9-pin micro-D
RJ45 connector
68-pin high density
15-pin high density D-SUB
2x4-pin USB
6-pin PS/2 female connector
USB Routing
Description
Parallel connector
Serial port 1, serial port 2
Ethernet connector
SCSI connector
Video connector
USB port 1, USB port 2
Keyboard/mouse