Pci/Pnp Setup; Plug And Play Aware Os; Pci Latency Timer (In Pci Clocks); Pci Vga Palette Snoop - Motorola CPV5000 Installation And Reference Manual

Compactpci single board computer

Table of Contents

WinBIOS Setup

PCI/PnP setup

PCI/PnP setup options are displayed by choosing the PCI/PnP Setup icon from

the WINBIOS Setup main menu. All PCI/PnP setup options are described in

this section.

Set this option to Yes if the operating system installed in the computer is Plug

and Play-aware. AMIBIOS only detects and enables PnP ISA adapter boards

that are required for system boot. Set this option to No if the operating system

does not use PnP. You must set this option correctly or PnP-aware adapter

boards installed in your computer will not be configured properly. The settings

are No or Yes.

This option sets latency of all PCI devices on the PCI bus. The settings are in

units equal to PCI clocks. The settings are 32, 64, 96, 128, 160, 192, 224, or

248.

This option must be set to Enabled if any ISA adapter board installed in the

computer requires VGA palette snooping. The settings are Disabled or

Enabled.

Set this option to Enabled to specify that the IDE controller on the PCI local

bus has bus mastering capability. The settings are Disabled or Enabled.

This option specifies if an offboard PCI IDE controller adapter board is used

in the computer. You must also specify the PCI expansion slot where the

offboard PCI IDE controller board is installed. If an offboard PCI IDE

controller is used, the onboard IDE controller on the CPV5000 is automatically

disabled. The settings are: Disabled, Auto, Slot1, Slot2, Slot3, or Slot4.

7-22

Table of Contents