Table of Contents
Advertisement
The floppy interface connector consists of a 34(2x17) pin shrouded header
available on the rear I/O transition module, or a flex cable connector for on-
board drive mounting.
Note
Parallel port
The parallel port supports ECP, EPP modes of operation.
The parallel interface connector is a 25-pin D-connector header available on
the rear I/O transition module, or a 25-pin micro-D connector on the front
panel.
Serial ports
The CPV5000 supports two serial ports. The ports support 16550 operation.
The serial interface connector is a 9-pin D style connector available on the rear
I/O transition module, or 9-pin micro-D connectors available on the front
panel. The serial ports are ESD protected to 15KV.
USB
The CPV5000 supports two USB ports with transfer capability from
1.2Mbits/second to 12Mbits/second.
Both ports are supported by two USB connectors on the front panel and the rear
I/O transition module. USB signals can be routed to the front or rear I/O
connectors using a four-position jumper block. USB can be enabled or disabled
in the BIOS setup.
• Jumper installed - rear connection
• Jumper removed - front connection
The rear I/O connected floppy and the on-board floppy
connection are mutually exclusive. You cannot use both at
the same time.
Parallel port
4
4-15
Advertisement
Table of Contents
