Table of Contents
Advertisement
Connecting to and configuring headers
The CPV5000 provides several headers for attaching peripheral devices.
Before you install the CPV5000, you may want to connect your peripheral
cables to the headers. Headers are circuit board-mounted components, as
opposed to connectors which are located on the CPV5000's front panel and
transition module.
Note
Please note the following cautions when connecting peripherals to the
CPV5000.
Always remove power from the system before connecting
!
peripherals to the CPV5000. To reduce the risk of personal
injury, disconnect the power cord from the power source.
Warning
Only qualified, experienced electronics personnel should
access the interior of a chassis.
The components of the CPV5000 are sensitive to static discharge.
!
While out of the unit, the CPV5000 should be placed on a static-
dissipative surface or into a static-shielding bag.
Caution
When the identical function is available through the
CPV5000's front panel and the rear transition module, you
can use either the front or the rear, not both.
Connecting to and configuring headers
3
3-3
Advertisement
Table of Contents
