Table of Contents
Advertisement
Power On Self-Tests
Checkpoint
code
86h
The password was checked. Performing any required programming before
WINBIOS Setup next.
87h
The programming before WINBIOS Setup has completed. Uncompressing the
WINBIOS Setup code and executing the AMIBIOS Setup or WINBIOS Setup
utility next.
88h
Returned from WINBIOS Setup and cleared the screen. Performing any necessary
programming after WINBIOS Setup next.
89h
The programming after WINBIOS Setup has completed. Displaying the power on
6
screen message next.
8Bh
The first screen message was displayed. The <WAIT...> message is displayed.
Performing the PS/2 mouse check and extended BIOS data area allocation check
next.
8Ch
Programming the WINBIOS Setup options next.
8Dh
The WINBIOS Setup options are programmed. Resetting the hard disk controller
next.
8Fh
The hard disk controller was reset. Configuring the floppy drive controller next.
91h
The floppy drive controller was configured. Configuring the hard disk drive
controller next.
95h
Initializing the bus option ROMs from C800 next. See Table 6-7 for additional
information.
96h
Initializing before passing control to the adaptor ROM at C800.
97h
Initialization before the C800 adaptor ROM gains control has completed. The
adaptor ROM check is next.
98h
The adaptor ROM had control and has now returned control to BIOS POST.
Performing any required processing after the option ROM returned control.
99h
Any initialization required after the option ROM test completed. Configuring the
timer data area and printer base address next.
9Ah
Set the timer and printer base addresses. Setting the RS-232 base address next.
9Bh
Returned after setting the RS-232 base address. Performing any required
initialization before the coprocessor test next.
9Ch
Required initialization before the coprocessor test is over. Initializing the
coprocessor next.
6-14
Table 6-6. Runtime checkpoint codes (Continued)
Description
Advertisement
Table of Contents
