Motorola CPV5000 Installation And Reference Manual page 5

Compactpci single board computer
Table of Contents

Advertisement

All Motorola PWBs (printed wiring boards) are manufactured by UL-recognized
manufacturers, with a flammability rating of 94V-0.
This equipment generates, uses, and can radiate electro-
!
magnetic energy. It may cause or be susceptible to electro-
WARNING
magnetic interference (EMI) if not installed and used in a
cabinet with adequate EMI protection.
If any modifications are made to product, the modifier
assumes responsibility for radio frequency interference issues.
Changes or modifications not expressly approved by
Motorola Computer Group could void the user's authority to
operate the equipment.
European Notice: Board products with the CE marking comply with the EMC
Directive (89/336/EEC). Compliance with this directive implies conformity to the
following European Norms:
EN55022 (CISPR 22) Radio Frequency Interference, Class B
EN50082-1 (IEC801-2, IEC801-3, IEC801-4) Electromagnetic Immunity
The product also fulfills EN60950 (product safety) which is essentially the
requirement for the Low Voltage Directive (73/23/EEC).
This board product was tested in a representative system to show compliance with
the above mentioned requirements. A proper installation in a CE-marked system
will maintain the required EMC/safety performance.
For minimum RF emissions, it is essential that you implement the following
conditions:
Install shielded cables on all external I/O ports
Connect conductive chassis rails to earth ground to provide a path for
connecting shields to earth ground
Tighten all front panel screws

Advertisement

Table of Contents
loading

Table of Contents