Table of Contents
Advertisement
BootUp sequence
This option sets the sequence of boot drives that the AMIBIOS attempts to boot
from after AMIBIOS POST completes.
The first boot device can be any of the following: IDE floppy, floptical, CD
ROM, SCSI, or network.
The second boot device can be any of the following: Disabled, IDE loptical, or
CD ROM.
The third boot device can be any of the following: Disabled, IDE optical, or
CD ROM.
BootUp NumLock
Set this option to Off to turn the Num Lock key off when the computer is
booted. This enables you to use the arrow keys on both the numeric keypad and
the keyboard. The settings are On or Off.
Floppy drive swap
Set this option to Enabled to permit drives A: and B: to be swapped. The
settings are Enabled or Disabled.
Floppy drive seek
Set this option to Enabled to specify that floppy drive A: will perform a seek
operation at system boot.
Mouse support
When this option is set to Enabled, AMIBIOS supports a PS/2-type mouse.
The settings are Enabled or Disabled.
Primary display
This option specifies the type of display monitor and adapter in the computer.
The settings are Mono, CGA40, CGA80, EGA/VGA, or Absent.
WinBIOS Setup types
7-13
7
Advertisement
Table of Contents
