Installation And Setup; Unpacking; Preparing The Board For Use; Providing Power To The Board - Motorola M5271EVB User Manual

2.2

Installation and Setup

The following sections describe all the steps needed to prepare the board for operation.
Please read the following sections carefully before using the board. When you are preparing
the board for the first time, be sure to check that all jumpers are in the default locations.
Default jumper markings are documented on the master jumper table and printed on the
underside of the board. After the board is functional in its default mode, the Ethernet
interface may be used by following the instructions provided in Appendix A.
2.2.1

Unpacking

Unpack the computer board from its shipping box. Save the box for storing or reshipping.
Refer to the following list and verify that all the items are present. You should have
received:
• M5271EVB Single Board Computer
• M5271EVB User's Manual (this document)
• One RS232 communication cable
• One BDM (Background Debug Mode) "wiggler" cable
• MCF5271UM ColdFire Integrated Microprocessor User Manual
• ColdFire® Programmers Reference Manual
• A selection of Third Party Developer Tools and Literature
Avoid touching the MOS devices. Static discharge can and will
damage these devices.
Once you have verified that all the items are present, remove the board from its protective
jacket and anti-static bag. Check the board for any visible damage. Ensure that there are no
broken, damaged, or missing parts. If you have not received all the items listed above or
they are damaged, please contact Freescale Semiconductor immediately - for contact
details please see the front of this manual.
2.2.2

Preparing the Board for Use

The board, as shipped, is ready to be connected to a terminal and power supply without any
need for modification.Figure 2-5., "Jumper Locations" - shows the position of the jumpers
and connectors.
2.2.3

Providing Power to the Board

NOTE
Chapter 2. Initialization and Setup
Installation and Setup
2-3