Table of Contents
Advertisement
Freescale Semiconductor, Inc.
BEFORE REMOVING OR INSTALLING ANY
EQUIPMENT IN THE SUN-4 COMPUTER, TURN
THE POWER OFF AND REMOVE THE POWER
CORD.
A.3.1
ADI Installation in the SUN-4
There are no jumper options on the ADI board for the Sun-4 computer. The ADI board can be inserted into
any available SBus expansion slot on the motherboard.
Refer to the appropriate Installation and Setup manual for the Sun-4 computer for instructions on removing
the computer cover and installing the board in an expansion slot.
ADI
Connector
Following is a summary of the Instructions in the Sun manual:
1. Turn off power to the system, but keep the power cord plugged in. Be sure to save all open files and
then the following steps should shut down your system:
•
hostname% /bin/su
•
Password: mypasswd
•
hostname# /usr/etc/halt
•
wait for the following messages.
Syncing file systems... done
Halted
Program Terminated
Type b(boot), c(continue), n(new command mode)
•
When these messages appear, you can safely turn off the power to the system unit.
2. Open the system unit. Be sure to attach a grounding strap to your wrist and to the metal casing of the
power supply. Follow the instructions supplied with your system to gain access to the SBus slots.
3. Remove the SBus slot filler panel for the desired slot from the inner surface of the back panel of the
system unit. Note that the ADI board is a slave only board and thus will function in any available SBus
slot.
4. Slide the ADI board at an angle into the back panel of the system unit. Make sure that the mounting
plate on the ADI board hooks into the holes on the back panel of the system unit.
M68360QUADS-040 Hardware User's Manual
CAUTION
FIGURE A-3 ADI board for SBus
For More Information On This Product,
Go to: www.freescale.com
SUPPORT INFORMATION
SBus
Connector
53
Advertisement
Table of Contents
